21.07.2010 STRONG is to license THOMSON brand for free-to-air set-top boxes
The STRONG Group announces that it is to license THOMSON brand. 
10.05.2010 STRONG's DVB-T receivers
Terrestrial MPEG-2 receivers are a big success in Croatia
06.05.2010 STRONG SlimSat Antennas
New SlimSat satellite antennas with integrated Single, Twin or Quad LNB
05.05.2010 New HD Receiver SRT 7100
Great performance and flexibility with recording capability and IR Extender
Terrestrial FTA SRT 55
|
|
DemodulatorDemodulator: 16 QAM/64 QAM, QPSK Video DecoderProfile level: MPEG2 MP@MLVideo resolution: 720 x 576 pixels (PAL), 720 x 480 (NTSC) Decoding & Video Out: PAL & NTSC Aspect ratio: 4:3 Letterbox, 4:3 Pan & Scan, 16:9 Audio DecoderMPEG MusiCam Layer IISampling rate: 32, 44.1, 48 KHz Audio mode: Stereo, Joint Stereo, Dual Mono, Mono TunerFront End: DVB-T, UHF & VHF TunerInput frequency range: 174 – 230 MHz (VHF) and 470 - 862 MHz (UHF) Input signal level: -78 ~-20 dBm | MultimediaVideo recording and playback – MPEG1 and MPEG2 encoded (mpg), DVRAudio playback – MP3 and WMA Picture view – JPEG format Memory and SystemVideo recording and playback – MPEG1 and MPEG2 encoded (mpg), DVRAudio playback – MP3 and WMA Picture view – JPEG format ConnectorsANT IN - IEC 169-2 FemaleTV SCART (RGB, CVBS) SD Card port IR remote port General DataSupply Voltage 5 V DCPower Consumption: < 4.5 W Power consumption in Standby: <1 W Operating Temperature: 0°~ 40°C Storage Temperature: -30°~ 80°C Operating Humidity Range: 10~85%, RH, Non-condensing Size (WxDxH) in mm: 69 x 137,5 x 20,5 Weight: 102 g |
EAN code SRT 55: 8717 185 444 759
Subject to alterations. In consequence of continuous research and development technical specifications, design and appearance of products may change. All product names are trademarks or registered trademarks of their respective owners.
© STRONG 2010. All rights reserved.
Subject to alterations. In consequence of continuous research and development technical specifications, design and appearance of products may change. All product names are trademarks or registered trademarks of their respective owners.
© STRONG 2010. All rights reserved.
| User Manual | Leaflet | Software |
|---|---|---|
|
Problem
|
Possible cause
|
What to do
|
|---|---|---|
|
IR sensor light not lit
|
Mains lead unplugged/multipoint connector switched off
Mains fuse blown
Bad connection of IR sensor plug
|
Check mains lead /switch multipoint connector on
Check fuse
Check connection
|
|
No signal found
|
Aerial is disconnected
Aerial is damaged/misaligned
Out of digital signal area
Active antenna requires to switch ON antenna power/external feed
|
Check aerial lead
Check aerial
Check with dealer
Switch receiver’s Antenna Power ON/ connect external feed
|
|
No picture or sound on TV
|
Scart is not selected on your TV
TV or VCR are not connected to main
|
Switch to correct TV input
Check mains lead
|
|
Scrambled channel
message
|
Channel is scrambled
|
Select alternative channel
|
|
No response to remote control
|
Receiver off
Handset not aimed correctly
IR sensor obstructed
Hand set batteries exhausted
|
Plug in and turn on plug
Aim handset at IR sensor
Check for obstructions
Replace handset batteries
|
|
Forgotten channel lock code
|
|
Re-install channels to cancel
channel lock
|
|
Forgotten menu lock
code
|
|
Contact local Service Hotline or send email to our Support via www.strong.tv
|
|
After moving the receiver to another room you are no longer able to receive digital reception
|
The aerial feed former new point
may come through a distribution
system which may reduce the
digital signal now received by the
box.
|
Try a direct feed from the antenna
|